Type the correct answer in each box.
Balance the chemical equation.
N₂O3-
N₂ +
0₂

The solid would be caught on a filter paper or membrane while the liquid passes through.

Filtration is used to separate a mixture of insoluble substances in a liquid.

Since the aim is to separate the insoluble component of the mixture from the liquid, filtration using a suitable filter paper or membrane will be the way out.

The liquid will pass through the filter paper or the membrane while the insoluble component will be caught. This can then be dried and collected accordingly.

More on filtration can be found here: https://brainly.com/question/12674010

#SPJ1

Answer :]

to convert from g NaOH to mol NaOH. = 1.48 g NaOH are needed to neutralize the acid.

In this model, electrons are found on unique levels and when jumping from one level to another, electrons emit light at a specific wavelength.

The Bohr model is an atomic model describing the properties of atoms and their constituents (electrons).

This model states different atoms have specific levels of energy where electrons can be located.

In conclusion, in this model, electrons are found on unique levels and when jumping from one level to another, electrons emit light at a specific wavelength.

Learn more about the Bohr model here:

https://brainly.com/question/18002213

#SPJ1

Answer:

In the Bohr model, electrons can exist only in certain energy levels surrounding the atom. The energy levels in each atom are unique. When electrons jump from a higher energy level to a lower one, they emit light at a wavelength that corresponds to the energy difference between the levels.

Explanation:

Ed22

Answer:

See below ~

Explanation:

A to B

⇒ Solid Phase

==========================================================

B to C

⇒ Melting

==========================================================

C to D

⇒ Liquid Phase

==========================================================

D to E

⇒ Vaporizing

============================================================

E to F and beyond

⇒ Gas Phase

The new volume of the gas given the data from the question is  1/2X mL

Data obtained from the question

Initial volume (V₁) = X mL

Initial pressure (P₁) = 2 atm

New pressure (P₂) = 4 atm

New Volume (V₂) = ?

How to determine the new volume

The new volume of the gas can be obtained by using the Boyles’ law equation as illustrated below:

P₁V₁ = P₂V₂

2 × X = 4 × V₂

2X = 4V₂

Divide both side by 4

V₂= 2X / 4

V₂ = 1/2X mL

Learn more about gas laws:

https://brainly.com/question/6844441

#SPJ1

The mass of [tex]Na_2CO_3[/tex] that will be required to be dissolved in water would be 15.9 grams

Recall that:  molarity = mole/volume in L

In this case, the volume is 0.3 L and the molarity is 0.5 M.

Thus, mole = molarity x volume = 0.5 x 0.3 = 0.15 moles

Mass of 0.15 moles  [tex]Na_2CO_3[/tex] = 0.15 x 106 = 15.9 grams

More on solution preparation can be found here: https://brainly.com/question/14667249

#SPJ1

The moles of unknown weak acid (HA) in a 100L solution are required to produce a solution with pH 2 is 0.002 moles.

The acid dissociation constant of an acid is given by the formula below:

[tex]K_a= \frac{[A^{-}][H_3O^{-}]}{[HA]}[/tex]

Where

Since, the Ka is given at equilibrium concentrations, [H3O+] = [A-]

[A-] = 10^-2

Making [HA] subject of the formula:

[tex][HA]= \frac{[10^{-2}][10^{-2}]}{5 \times 10^{ - 3} } = 0.02[/tex]

Moles of acid = 0.1 × 0.02 = 0.002 moles

Therefore, the moles of unknown weak acid (HA) in a 100L solution are required to produce a solution with pH 2 is 0.002 moles.

Learn more about acid dissociation constant at: https://brainly.com/question/9560811

#SPJ1

According to the postulates of kinetic molecular theory, the particles of a liquid are close together and are in constant random motion.

The Kinetic theory of matter states that all forms of matter are made up of tiny particles which possess kinetic energy and are in constant state of motion.

The strength of the forces keeping the particles together determines the state in which that substance exists in.

For liquids, the intermolecular forces of attraction between between the molecules are not very strong, and as such, the particles of a liquid are in constant state of random motion.

Therefore, according to the postulates of kinetic molecular theory, the particles of a liquid are close together and are in constant random motion.

Learn more about kinetic theory of matter at: https://brainly.com/question/15357425

#SPJ1

After 160 years, the activity level of the sample will be 0.5 curies.

Half life of any radioactive waste is the half decay of that product.

The formula is [tex]\dfrac{\lambda }{\lambda_1} = 2^\dfrac{a}{b}[/tex]

Where, λ is 4 cruies

λ1 is 0.5 cruies

b = 40 years

Putting the values in the equation

[tex]\dfrac{4}{0.5} = 2^\dfrac{a}{40}\\\\\\\dfrac{a}{40} = 4\\ = 160 years[/tex]

Thus, the correct option is 160 years.

Learn more about half-life

https://brainly.com/question/24710827

#SPJ4

Answer:

The answer is D.

Explanation:

Including soluble fiber into your diet can lower cholesterol levels.

A gas at STP is heated to 35 degree C. The new pressure will be 2.41 atm.

The pressure of the mass of the gas is directly proportional; to the temperature of the gas.

[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}[/tex]

Converting the temperature into kelvin

The initial temperature = 35 °C = 35 + 273 K= 308 K

The final temperature = 50 °C =50 + 273 K = 323 K

Initial pressure = 2.3 atm

Final pressure ?

Putting the values in the equation

[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}\\\\\\{P_2 = \dfrac{P_1 \times T_2}{T_1} \\\\\\\\\\{P_2 = \dfrac{2.3 \times 323 }{308} = 2.41 atm.[/tex]

Thus, the new pressure will be 2.41 atm.

Learn more about Gay-Lussac law

https://brainly.com/question/11387781

#SPJ1

Americium is a radioactive element .

The nuclear reaction.is given by

[tex]\rm {}^{241}_{95}Am\longrightarrow {}^{237}_{93}Np+{}^4_2\alpha[/tex]

Here alpha can be written as He too

The balanced redox reaction, if it occurs in acidic solution, is

5C₂O₄²⁻(aq) + 2MnO₄⁻(aq) + 16H⁺-----> 10CO₂(g) + 2Mn²⁺(aq) + 8H₂O(l)

Redox reactions are those in which loss and again of electrons occur.

To balance the redox reaction, we must first break the whole reaction into half equations;

Oxidation half equation

[tex]\rm 5C_2O4^2^-(aq) + 10e + 8H^+----- > 10CO_2(g) + 4H_2O(l)[/tex]

Reduction half equation

[tex]\rm 2MnO_4^- (aq) + 10e + 8H^+----- > 2Mn^2+(aq) + 4H_2O(l)[/tex]

Now combine both the reactions

[tex]\rm 5C_2O_4^2-(aq) + 2MnO4^- (aq) + 16H^+----- > 10CO_2(g) + 2Mn^2+(aq) + 8H_2O(l)[/tex]

Thus, the coefficient of H₂C₂O₄ is 5 and that of water is 8.

Learn more about redox reactions

https://brainly.com/question/13293425

#SPJ4

The conductance of the electric current through the electrolytic solution increases with increase in concentration.

An electrolytic solution is a solution containing dissolved electrolyte.

The ions of the electrolyte dissociate and are able to carry electric current around the electrolytic cell.

The higher the concentration of the electrolyte, the more electric current it can conduct due to greater number of ions present.

Therefore, the conductance of the electric current through the electrolytic solution increases with increase in concentration.

Leran more about electrolytes at: https://brainly.com/question/1961090

#SPJ1

Answer:

Increases

Explanation:

The general effect we see as temperature increases is that rate of dissolution of a solid solute increases,

Therefore, we can say that :

Temperature ∝ Rate of dissolution

Answer: 16.7 %

Explanation:

[tex]\frac{30.0}{150.0+30.0}=\boxed{16.7\%}[/tex]

The actual yield of the experiment given the data from the question is 92.4 g (Option B)

This is the ratio of the actual yield to the theoretical yield of a given reaction multiplied by 100

Percentage yield = (Actual / Theoretical) × 100

This is the amount obtained from the expriment procedures

This is the amount obtained from simple calculations as regarding the experiment.

Actual yield = percentage yield × theoretical yield

Actual yield = 80.34% × 115

Actual yield = 0.8034 × 115

Actual yield = 92.4 g

Learn more about stoichiometry:

https://brainly.com/question/14735801

#SPJ1

You could let the air out of the balloon while it is under the water with a container filled with water upside down over it. And measure the water displacement.

Answer:

What is the difference between pools and fluxes?

Image result for Is industry pool or flux

Fluxes describe the movement of energy and matter between different pools. When you pour a glass of juice for yourself, the juice bottle and the glass are both “pools” for the apple juice. The act of pouring it from the bottle to the glass is the flux

Explanation:

The wave which is created by causing vibrations in particles of matter is a mechanical wave.

A wave is a disturbance in a medium which transmits transmits energy from one point to another without a permanent displacement of the particles of the medium.

Types of waves include:

Mechanical waves are waves which are produced as a result of the vibrations of the particles of the medium.

Therefore, the wave which is created by causing vibrations in particles of matter is a mechanical wave.

Learn more about mechanical waves at: https://brainly.com/question/26393035

#SPJ1

Answer:

During DNA replication, each of the two strands that make up the double helix serves as a template from which new strands are copied. The new strand will be complementary to the parental or “old” strand. Each new double strand consists of one parental strand and one new daughter strand.

Explanation:

hope it helps you

Addition of pure water does not change pH of a solution because pure water has neutral pH.

Even though you continue to add pure water into a substance, the acidity or alkalinity of substance still remains the same to that of substance because pure water has neutral pH which can't change the acidity or alkalinity of a solution.

So we can conclude that addition of pure water does not change pH of a solution because pure water has neutral pH.

Learn more about acid here: https://brainly.com/question/25148363

#SPJ1

The volume of excess oxygen will 2.28 L

From the equation of the reaction:

[tex]CH_4(g) + 2O_2(g) --- > CO_2(g) + 2H_2O(g)[/tex]

The mole ratio of the two reactants is 1:2.

1 mole of gas at STP = 22.4 L

Mole of 29.2 L of methane at STP = 29.2/22.4 = 1.3 moles

Mole of 63.3 L of oxygen at STP = 63.3/22.4 = 2.8 moles.

Thus, oxygen is in excess because 1.3 x 2 = 2.6 moles is needed to react with 1.3 moles methane.

Excess mole of oxygen = 2.8 - 2.6 = 0.2 moles

Volume of 0.2 moles at STP = 22.4 x 0.2 = 2.28 L

More on stoichiometric calculations can be found here: https://brainly.com/question/27287858

#SPJ1

From the calculations, the heat of fusion of the substance is 0.73 kJ

The heat of freezing is the energy released when the substance is converted from liquid to solid.

Now we know that the molar mass of the substance is 82.9 g/mol  hence the number of moles of the substance is;  13.3 g /82.9 g/mol  = 0.16 moles

Now the heat of fusion shall be;

H = 4.60 kj/mol * 0.16 moles

H = 0.73 kJ

Learn more about freezing:https://brainly.com/question/3121416

#SPJ4

Answer:

increasing the pressure

Explanation:

You can make a solution more concentrated by increasing the pressure.

The total pressure in the container after the three gases are mixed is 6 atm and the partial pressure of He is 1 atm.

According to Dalton's Law of Partial Pressure , the pressure exerted by a mixture of gas is equal to the sum of the partial pressure of the gases in the mixture.

P(total) = p₁ +p₂+p₃+.....

As the volume of the containers are same and the

n = 1*5/RT for Helium

n = 2*5 /RT for Neon

n= 3*5/RT for Argon

Mole fraction = moles of the element/Total moles

Moles fraction of Helium is

[tex]\rm \dfrac{1*5}{1*5+2*5+3*5}[/tex]

= 1/6

Total Pressure in the container = 1 + 2 +3 = 6 atm

The partial pressure of Helium will be

=Mole fraction * Total pressure

=(1/6)*6 atm

= 1 atm , as the volume is same the temperature is same , the pressure will also be same.

To know more about Dalton's Law

https://brainly.com/question/14119417

#SPJ1