Three examples where is helpful to have a low reaction rate

Answer:

5.6 m which is molarith this solution

Organic compounds including carboxylic acids are named uisng IUPAC nomenclature technique.

A carboxylic acid is an organic acid that contains a carboxyl group (C(=O)OH) attached to an R-group.

The general formula of a carboxylic acid is R−COOH or [tex]RCO_2H[/tex], with R referring to the alkyl, alkenyl, aryl, or other group.

Following are the names of given struture ;

Learn more about Carboxylic acids here ;
https://brainly.com/question/26855500

#SPJ1

The ionization constant from the reaction as shown in the calculation is 5.8.

The term ionization constant refers to the extent to which the acid is ionized in solution. It is calculated from;

Ka = [H3O^+] [Cl]/[HCl]

Thus when we substitute the values;

Ka = 13.3 * 7.4/ 16.9

Ka = 5.8

The ionization constant from the reaction as shown in the calculation is 5.8.

Learn more about ionization constant:https://brainly.com/question/13794673

#SPJ1

The increase in volume shift the equilibrium towards making more moles of gas, decrease in volume shift the equilibrium towards producing fewer moles of gas.

The equilibrium of the gas is based on the pressure of the gas. With the increase in pressure, the equilibrium moves towards making fewer molecules of gas.

The gas equilibrium is proportional to the equilibrium K.

Increase in volume shift the equilibrium towards making more moles of gas, decrease in volume shift the equilibrium towards producing fewer moles of gas.

Learn more about equilibrium

https://brainly.com/question/13463225

#SPJ1

Answer:

4.25atm

Explanation:

[tex]\frac{P1V1}{T1}\\[/tex]=[tex]\frac{P2V2}{T2}[/tex]

where ,

p1 =845/760=1.11atm

v1=6.50l

t1=25c +273k=298k

p2=?

v2=1850/1000=1.85l

t2=325k

so answer is 4.25 atm

Since the reaction is not spontaneous at room temperature, the ΔH will be positive.

They are reactions that require no additional effort in order for them to take place under certain conditions.

For spontaneous reactions, the change in the energy of the system, otherwise known as ΔH, is always negative. On the other hand, reactions with positive ΔH are non-spontaneous.

More on spontaneous reactions can be found here: https://brainly.com/question/13790391

#SPJ1

Answer:

Look at the pH level.

Explanation:

The best way to determine whether a solution is acidic or basic is to look at its pH level. The pH of a solution is a number between 0 and 14.

If a solution has a pH of less than 7, then it is acidic.

If a solution has a pH of 7, then it is neutral.

If a solution has a pH of greater than 7, then it is basic.

hope this helps!! p.s. i really need brainliest :)

Answer: 80.9 K

Explanation:

[tex]Q=mc \Delta T\\\\1345=(43.2)(0.385) \Delta T\\\\\Delta T=\frac{1345}{(43.2)(0.385)} \approx \boxed{80.9 \text{ K}}[/tex]

Answer:

So A: an addition to a base sequence at the beginning of a gene

Explanation:

This is known as point mutation and it does not have any significant change in the protein and it is least harmful type of DNA mutation.

After 160 years, the activity level of the sample will be 0.5 curies.

Half life of any radioactive waste is the half decay of that product.

The formula is [tex]\dfrac{\lambda }{\lambda_1} = 2^\dfrac{a}{b}[/tex]

Where, λ is 4 cruies

λ1 is 0.5 cruies

b = 40 years

Putting the values in the equation

[tex]\dfrac{4}{0.5} = 2^\dfrac{a}{40}\\\\\\\dfrac{a}{40} = 4\\ = 160 years[/tex]

Thus, the correct option is 160 years.

Learn more about half-life

https://brainly.com/question/24710827

#SPJ4

Wavelengths of absorbed or emitted photons causes lines in a line spectrum.

Spectral lines are produced by transitions of electrons within atoms. As the electrons move closer or farther from the nucleus of an atom, energy is released in the form of light is emitted.

So we can conclude that Wavelengths of absorbed or emitted photons causes lines in a line spectrum.

Learn more about spectrum here: https://brainly.com/question/1968356

#SPJ1

Answer:

Oxygen and sugar

Explanation:

Hope this helps! Please give branliest.

Answer:

x+y = 12

Explanation:

shfb gfgjj ghjj dvgg ggggg ghggs ufac t g dgyyh

Answer: B - 0.0098 moles

Explanation:

<3

Answer: 16.7 %

Explanation:

[tex]\frac{30.0}{150.0+30.0}=\boxed{16.7\%}[/tex]

Answer:

Moles of substance are defined ratio of the given mass of the substance to the molar mass of the substance.

Given :

The 52.06 grams of carbon dioxide.

To find :

The moles of carbon dioxide.

Solution:

The mass of carbon dioxide = 52.06 g

The molar mass of carbon dioxide = 44.01 g/mol

The moles of carbon dioxide:

1.183 moles of carbon dioxide are there in 52.06 g of carbon dioxide.

Explanation:

Answer:

ywhehehehehdgdudcdudcd uy dshdcvv

Explanation:

bdbdkzkzjzdkdkzdvdisisksjskakskskzbx vxydcdudschahahbshshs

Answer:Your can use the internet There is a web site that is called periodic table.com it is very use full

Explanation:Have fun

Answer:

Highest wavelength : radio waves

So lowest energy: radio waves

Hence order is:

radio waves < microwaves < IR waves < visible light < ultraviolet radiation < X-rays < gamma rays

Answer:

the aNSWRER TOP UR QUESTION IS THAT I NMEED TO ANSWER THIS SO I DONT HAVE TO WQATCH ADS  LOL

Explanation:

DSADSDASDASDASDSDSDSDSDS and i knowq chem is bio chwem is

Answer:

B

Explanation:

The methyl prefix means theres a CH3 group bonded to a carbon in a hydrocarbon. This is called branching because it looks like a branched tree. This is literally cheating but you do you.

Answer:

Explanation:

You would have to add up the atomic masses of all the compounds in the compound, making sure you include how many molecules of each are in the compound

For example, in CuSOA we have 1 molecule of Cu and S, as 4 molecules of O

The atomic masses are as follows:

Cu = 63.55 u

S = 32.065 u

O = 15.99 units

This is how we would add it up:

(Atomic mass of Cu) + (Atomic mass of S) + 4(Atomic Mass of O)

(63.55) + (32.065) + 4(15.99)

(63.55) + (32.065) + 63.96

= 159.575 u

Answer:

Increases

Explanation:

The general effect we see as temperature increases is that rate of dissolution of a solid solute increases,

Therefore, we can say that :

Temperature ∝ Rate of dissolution

The molecular mass of the compound is required to calculate the molecular formula from the empirical formula.

A chemical formula that gives the total number of atoms of each element in each molecule of a substance.

Dividing the molar mass of the compound by the empirical formula mass. The result should be a whole number or very close to a whole number. Multiplying all the subscripts in the empirical formula by the whole number will give the resultant molecular formula.

Hence, the molecular mass of the compound is required to calculate the molecular formula from the empirical formula.

Learn more about the molecular formula here:

https://brainly.com/question/14425592

#SPJ1

The example of an ester used as a fragrance is isopentyl acetate and it is present in banana. Details about esters can be found below.

Esters are compounds most often formed by the condensation of an alcohol and an acid and has the functional group carbon-oxygen double bond joined via carbon to another oxygen atom.

Esters are naturally found in certain fruits and can be used as major constituent of perfumes. An example of ester used as fragrance is isopentyl acetate.

Isopentyl acetate has the molecular formula of C7H14O2 and has a banana flavor.

Learn more about esters at: https://brainly.com/question/10840252

#SPJ1

Answer: 341.6k

Explanation:

R= 0.0821

n= 0.46moles

v= 13.3L

p= 734mmhg = 734/760 = 0.97

[tex]T = \frac{p*v}{n*R}[/tex]

[tex]T = \frac{0.97*13.3}{0.46*0.0821}[/tex]

T= 341.6k

Answer:

10100101

Explanation:

this is for the other person alt.

Answer:

The concept of the atom (Greek: atomos, "indivisible"), an indivisible particle of matter, goes back to ancient Greece and a man named Democritus, a rival of Aristotle. Democritus held that all matter could be subdivided only until some finite particle was reached.Dalton's atomic theory was the first complete attempt to describe all matter in terms of atoms and their properties. Dalton based his theory on the law of conservation of mass and the law of constant composition. The first part of his theory states that all matter is made of atoms, which are indivisible.Atomic theory established that all matter is made of tiny particles, a discovery that led to amazing scientific breakthroughs in areas from modern chemistry to nuclear energy.Atomic models are important because, they help us visualize the interior of atoms and molecules, and thereby predicting properties of matter.This atomic model has changed over time. Scientists used the model to make predictions. Sometimes the results of their experiments were a surprise and they did not fit with the existing model. Scientists changed the model so that it could explain the new evidence.Atomic theory originated as a philosophical concept in ancient India and Greece. The word "atom" comes from the ancient Greek word atomos, which means indivisible. According to atomism, matter consists of discrete particles. However, the theory was one of many explanations for matter and wasn't based on empirical dataEverything is composed of atoms, which are the indivisible building blocks of matter and cannot be destroyed. All atoms of an element are identical. The atoms of different elements vary in size and mass. Compounds are produced through different whole-number combinations of atoms.Dalton's atomic theory suggested that the atom was indivisible and indestructible. But the discovery of two fundamental particles (electrons and protons) inside the atom, led to the failure of this aspect of Daltons atomic theory.

hope this is helpful