Please answer if you know :)

The forces necessary for calculating the total force are Fp and Fg. The correct option is d.

The force of attraction felt by a person at the center of a planet or Earth is called as the gravity.

The gravitational force, Fg is the attractive force exerted by the Earth on the object that is equal to the mass of the object times the gravitational acceleration.

Emmett is lifting a box vertically. There are only vertical forces acting on the box.

The vertical force must counteract the weight of the object, is the upward force applied on the object.

Thus, the forces necessary for calculating the total force is Fp - Fg.

Learn more about gravity.

brainly.com/question/4014727

#SPJ1

The frequency of an electromagnetic wave with wavelength of 10nm will be 3 × 10∧7 Hz and would belong to the X-ray or ultraviolet part of the electromagnetic spectrum due to its wavelength

What is frequency?

Frequency is defined as the number of oscillations of a wave per unit time and is measured in hertz(Hz).

It is also inversely proportional to the wavelength.

The frequency of an electromagnetic wave can be calculated using the formula;

frequency = velocity of light divided by the wavelength

f = v ÷ λ

Note that the velocity of light = 3 × 10 ∧8 m/s

Wavelength = 10nm

Frequency, f = 3 × 10∧8 ÷ 10 = 3 × 10∧7 Hz

Hence, the frequency of an electromagnetic wave with wavelength of 10nm will be 3 × 10∧7 Hz and would belong to the X-ray or ultraviolet part of the electromagnetic spectrum due to its wavelength.

Learn more about electromagnetic spectrum here:

https://brainly.com/question/13803241

#SPJ1

The reactance of the circuit will be 5.233×10⁻⁴ ohm. Inductive reactance is the product of 2 times π frequency and the coil inductance.

When alternating electricity passes through pure reactance, it causes a voltage drop that is 90 degrees out of phase with the current.

The letter “X” is used to represent reactance in mathematics, and it is measured in ohms.

The inductive reactance of a coil is calculated using the following formula:

Inductive reactance, or XL, is the product of 2 times p (pi), and the frequency of the ac current in hertz, and the coil inductance in henries.

XL= 2πfL

Where,

f {frequency)

L (Inductance)

The reactance of the circuit is found as;

[tex]\rm R_{new}=0.38[{(\frac{1}{60} )^2][/tex]

[tex]\rm R_{new}=1.055 \times 10^{-4} \ ohm[/tex]

The inductance of the circuit is;

[tex]\rm X_{new}=1.9(\frac{1}{60} )^2\\\\X_{new}= 5.233 \times 10^{-4}\ ohm[/tex]

Hence, the reactance of the circuit will be 5.233×10⁻⁴ ohm.

To learn more about the reactance, refer to the link;

https://brainly.com/question/17129912

#SPJ4

Answer:

3.2 [tex]10^{-2} ohm^{-1} m^{-1}[/tex]

Explanation:

Resistance=5 ohm

Length=4m

Cross sectional area=2.5 x 10

Conductivity = 1/ resistivity

                      =[tex]\frac{length}{resistance x cross sectional area}[/tex]

Conductivity=4 /5 x 2.5 x 10

Conductivity=4/125

Conductivity=3.2x[tex]10^{-2}[/tex][tex]ohm^{-1} m^{-1}[/tex]

The time it would take a 2500 W electric kettle to boil away 1.5 Kg of water is 2400 seconds

Use the formula:

Power × time = mass × specific heat

Given mass = 1. 5kg

Specific latent heat of vaporization = 4000000 J/ Kg

Power = 2500 W

Substitute the values into the formula

Power × time = mass × specific heat

2500 × time = 1. 5 × 4000000

Make 'time' the subject

time = 1. 5 × 4000000 ÷ 2500 = 6000000 ÷ 2500 = 2400 seconds

Therefore, the time it would take a 2500 W electric kettle to boil away 1.5 Kg of water is 2400 seconds.

Learn more about specific latent heat of vaporization:

https://brainly.in/question/1580957

#SPJ1

Answer:

Explanation:

1800x0.9=1620kg

Answer:

The momentum of the colliding bodies before and after the collision remains constant.

Explanation:

The momentum is constant.

answer: c

explanation: it's job is to store and release charge

Answer:

C- It stores and releases charge

From the calculations and the data provided, the speed is obtained as 15 m/s

The term momentum refers to the product of mass and velocity. Given that we can now proceed with the answer.

Since;

p = mv

m = 750kg

v = 5 km/hr or 1.4 m/s

p = 750kg *  1.4 m/s

p = 1050 kgm/s

If the mass of the body is 70kg, the speed is

v = p/m

v = 1050 kgm/s/70 Kg

= 15 m/s

Learn more about momentum:https://brainly.com/question/24030570

#SPJ1

Explanation:

Force = mass x acceleration

F= ma (formula)

15N = o.5kg x a

Divide both sides by o.5

a = 30 (greater acceleration)

15N = 4.5kg x a

Divide both sides by 4.5

a= 3.33 (great acceleration)

15N = 0.05kg x a

Divide both sides by 0.05

a = 300 (greatest acceleration)

The diagram is labelled to DRAW the RESULTANT wave and LABEL the areas of interference with CI, DI and/or points of TDI.

When a light ray falls on the interface of two medium like air and water, then the portion of light is reflected and another portion of the light is refracted into the water medium. The angle of incidence is equal to the angle of reflection but the angle of incidence is larger then the angle of refraction.

Open the attached file. It shows 2 waves (a blue one and an orange one) that are moving through the same medium at the same time.

Thus, the diagram is labelled.

Learn more about refraction.

https://brainly.com/question/14760207

#SPJ1

Answer:

Displacement...

Explanation:

Displacement is a vector quantity as it have both magnitude and direction...

[tex]...[/tex]

a. displacement is the correct answer

Displacement is a vector quantity

Displacement is a vector quantity because it has both magnitude and direction.

Answer:

power=work done÷time taken

2×5=10

10÷10=1

ans 1J per second

Answer:

False

Explanation:

It is actually I = V/R and V = I × R

Sian wants to count the number of seconds it takes for a beaker's contents to become purple from clear. She should utilize a stopwatch as her instrument for this job.

Watch that, when turned on and off, measures the amount of time that has passed since a specific time.

Sian wants to measure the number of seconds that it takes for the contents of a beaker to change from clear to purple. Stopwatch is the tool she should utilize for this purpose.

Hence, option B is correct.

To learn more about the stopwatch refer;

https://brainly.com/question/13758413

#SPJ1

Answer: Sian wants to count the number of seconds it takes for a beaker's contents to become purple from clear. She should utilize a stopwatch as her instrument for this job.

option b

Explanation:

The distance the 2.0-cm-diameter piston must be pushed down to raise 9 cm diameter is 607.5 cm.

The distance the piston must be pushed down is calculated as follows;

A₁d₁ = A₂d₂

πr₁²d₁ = πr₂²d₂

r₁²d₁ = r₂²d₂

(1)²(d₁) = (4.5)²30

d₁ = 607.5 cm

Thus, the distance the 2.0-cm-diameter piston must be pushed down to raise 9 cm diameter is 607.5 cm.

Learn more about piston here: https://brainly.com/question/25870707

#SPJ1

Answer:

the potential energy a massive object has in relation to another massive object due to gravity

Answer:

PE uses the acceleration of gravity in its calculation definition

Explanation:

Potential Energy = mass * acceleration of gravity * height

Cheer dance​ is a routine composed of yells and cheers gymnastic skill and dance.  

Cheer dance or cheerleading is a group activity used to entertain fans at athletic events and inspire louder, more enthusiastic cheering. It combines dancing and acrobatic aspects with shouted phrases.

A never-ending range of diverse stunts, jumps, pyramids, dances, and chants that integrate a variety of different movements can be included in the immensely complex sport of cheerleading. Base, partner, and spotter are the three primary cheerleading roles. These roles are all a part of cheerleading stunts, which pose the greatest risk of harm to participants.

It is a competitive sport and leisure activity made up of a set routine with necessary performance components, much like in gymnastics and dance. Additionally, it hopes to get the crowds to cheer in team sports event.

Learn more about cheer dance, refer the link:

https://brainly.com/question/29788167

#SPJ2

Your question is incomplete, but most probably your full question was:

1. It is a routine composed of yells and cheers, gymnastic skills and dance.

A. Contemporary dance

B. Hip-hop dance

C. Street dance

D. Cheer dance​

Answer: 20 minutes

Explanation: omm its 20 minutes

Diagonal of cardboard=displacement to hole

So displacement till edge

Total distance

From centre to hole displacement

The resultant of the two 10N forces acting at a point in the given direction is the single force which will have the same effect as all the forces acting at that point.

The resultant of two or more forces is that single force which will have the same effect as all the forces acting at that point in a given direction.

Since forces are vector quantities, the resultant force is obtained by vector addition.

The direction of the forces are also obtained.

Therefore, the resultant of the two 10N forces acting at a point in the given direction is the single force which will have the same effect as all the forces acting at that point.

Learn more about resultant force at: https://brainly.com/question/8119756

#SPJ1

The earth tilt about 23 degrees which leads to the formation of seasons on earth.

This is tilted at 23 degrees from the vertical. The northern hemisphere is in the winter season.

This is the path as the earth revolves around the sun. It takes 1 year to complete this path.

This is the path as the earth rotates around its.

So we can conclude that the earth tilt about 23 degrees which leads to the formation of seasons on earth.

Learn more about season here: https://brainly.com/question/25870256

#SPJ1

Answer:

Then our fires would become massive.

Explanation:

Hope this helps

The statement indicating that 'Gravitation always does negative work' is FALSE.

Gravitation is a fundamental physical force that makes objects attract each other in the Universe.

This force (Gravitation) is required to maintain both constant positions and movement of objects.

In conclusion, the statement indicating that 'Gravitation always does negative work' is FALSE.

Learn more about Gravitation here:

https://brainly.com/question/557206

#SPJ1

Answer:false

Explanation:

The final velocity of the second person after the collision is determined as 1.6 m/s to the right.

The final velocity of the second person is determined by applying the principle of conservation of linear momentum.

m1u1 + m2u2 = m1v1 + m2v2

85.2(0) + 65.4(0) = 85.2(-1.2) + 65.4(v2)

0 = -102.24 + 65.4v2

65.4v2 = 102.24

v2 = 1.56 m/s to the right

Thus, the final velocity of the second person after the collision is determined as 1.6 m/s to the right.

Learn more about linear momentum here: https://brainly.com/question/7538238

#SPJ1

Answer:

18 000 m/ s

Explanation:

speed = wavelength * frequency

speed =  1.2  * 15 000 = 18 000 m/s

Answer:

4.0208 x 10^16 meters

Explanation:

speed of light in m/s   *      # seconds in a year      * 4.25 years =

2.99792 x 10^8   *        3600*24*365.25  *     4.25 = 4.0208 x 10^16 m

Answer:

Gravity is what holds the planets in orbit around the sun and what keeps the moon in orbit around Earth. The gravitational pull of the moon pulls the seas towards it, causing the ocean tides. Gravity creates stars and planets by pulling together the material from which they are made.

Explanation: Hope it helps you :))))

Have a good day

Answer:

The law of conservation of mass states that the total energy of an isolated system remains constant over time.

Explanation: Hope it helps you :))))

Have a good day