In a receptacle we have 29 g of hydrochloric acid that react with an excess of ammonia according the following equation:
HCl + NH3 → NH4Cl
The percent yield of the reaction is 54 %. Determine:
1.Mass of ammonium chloride obtained.
2.How many moles of ammonium chloride are forme

Answer:

ako po kailangan ko po nga ayuda

Explanation:

thanks for the points ❤️

Answer:

[tex]T_F=-4.4\°C[/tex]

Explanation:

Hello there!

In this case, according to the given information, it is possible for us to calculate the freezing point of an aqueous solution of potassium sulfide by using the following equation:

[tex]T_F=T_{solv}-i*m*Kf[/tex]

In such a way, we firstly calculate the molality of this solution according to:

[tex]m=\frac{\frac{13g}{110.262 g/mol} }{0.150kg} =0.79m[/tex]

Finally, since the Van't Hoff's factor for K2S is 3, the freezing point of the solution turns out to be:

[tex]T_F=0\°C-3*0.79m*1.86\°C/m\\\\T_F=-4.4\°C[/tex]

Regards!

Answer:

Any element in group 18 has eight valence electrons (except for helium, which has a total of just two electrons

Answer:d

Explanation:

Answer:

I think that the volume will be 1.414

Explanation:

According to the formula of boyle's law P1 V1 = P2 V2

We have to find V2 so:

V2 = P2/P1 V1

By putting the values:

V2 = 5.06/2.11 * 1.696

V2 = 5.06/3.578

V2 = 1.414

Please give me brainliest, it will mean a lot to me.

Answer:

Combustion

Explanation:

Answer:

Measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water

Explanation:

To make 100 mL of 0.001 mM solution from 0.0405mM solution, we need to determine the volume of 0.0405mM solution needed. This can be obtained as follow:

Molarity of stock (M₁) = 0.0405 mM

Volume of diluted (V₂) = 100 mL

Molarity of diluted solution (M₂) = 0.001 mM

Volume of stock solution needed (V₁) =?

M₁V₁ = M₂V₂

0.0405 × V₁ = 0.001 × 100

0.0405 × V₁ = 0.1

Divide both side by 0.0405

V₁ = 0.1 / 0.0405

V₁ = 2.47 mL

Therefore, to make 100 mL of 0.001 mM solution from 0.0405mM solution, measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water.

Answer:

34.44 kg

Explanation:

First we convert 1.00 kg of phosphorus (P) into moles, using its molar mass:

Then we convert 0.03125 kmoles of P into kmoles of Ca₃(PO₄)₂:

Now we calculate the mass of 0.0625 kmoles of Ca₃(PO₄)₂:

Finally we calculate the required mass of the ore, using the definition of content percentage:

A.

Particles and energy in a system become more and more disordered.

Answer:

True

Explanation:

The tertiary structure of a protein is a complex arrangement formed as the polypeptide chain folds and twists.

This folding & twisting of polypeptide chain leading to its complex structure, is true about tertiary structure of protein. It occurs due to different interactions between side chains of amino acids.

Answer:

Sis I think it happened with me but I am not able to remember if u want u can share if it happened with u

Answer:

The key difference between group 1 and group 2 elements is that all group 1 elements have unpaired electrons in their outermost orbital, whereas group 2 elements have paired electrons in their outermost orbital.

The hardness of group 2 elements are harder than group 1 elements because they have a strong metallic  bond and atoms are closely packed.

The group 1 elements are alkali metals and group 2 elements are alkaline earth metals. Group 1 contain 7 elements. Group 2 has 6 elements.

The difference between,  group 1 elements have unpaired electrons in their outermost orbital, whereas group 2 elements have paired electrons in their outermost orbital.

Thus, the hardness of group 2 elements are harder than group 1 elements because they have a strong metallic  bond and atoms are closely packed.

Learn more about group 1 and 2 elements

https://brainly.com/question/867686

#SPJ2

Answer:

True

Explanation:

Explanation:

Explanation:

[tex]H _{2}O _{2(aq)} →H _{2}O _{(l)} + O _{2}(g) \\ solution : 2 \: and\: 2[/tex]

Answer:

C

Explanation:

energy from different sources leads to different types of rocks. energy inside the earth(volcanoes) melts rocks into liquid rock(molten larva) but energy from the sun(heat radiation) causes rock to weather(breakdown) into small pieces of rocks

Explanation:

Molarity = (# of moles)/(# of liters)

= 180 mol MgCl2/60 L

= 3.0M MgCl2

Answer:

When blood is too basic, carbonic acid can ionize to bicarbonate and H+ ions, adding H+ ions to the blood.

When blood becomes too acidic, bicarbonate combines with extra H+ ions to form carbonic acid, removing H+ ions from the blood.

Carbonic acid can raise or lower the pH of blood.

Explanation:

A buffer is a solution that resists changes to its pH when small quantities of acids or bases are added to it. The human blood serves as a buffer as it contains a buffer of carbonic acid (H2CO3) and bicarbonate anion (HCO3-) which serves to maintain blood pH between 7.35 and 7.45. Other buffering systems in blood exist such as the Hydrogen ion and oxygen gas which affects oxygen binding to haemoglobin, however the carbonic-acid-bicarbonate buffer is the most important buffer for maintaining acid-base balance in the blood.

A buffer solution is made up of an acid and its conjugate base or a base and its conjugate acid. For carbonic acid-bicarbonate buffer, carbonic acid serves as the acid while bicarbonate serves as the base. When a little quantity of a base as hydroxide ions is added to a buffer, the acid reacts with it and remove it from the solution. On the other hand, when a little quantity of an acid as hydrogen ions are added to a buffer, the conjugate base reacts with it and remove it from the solution, thus keeping the pH of the solution fairly constant.

In the carbonic acid-bicarbonate buffer:

When blood is too basic, carbonic acid can ionize to bicarbonate and H+ ions, adding H+ ions to the blood.

When blood becomes too acidic, bicarbonate combines with extra H+ ions to form carbonic acid, removing H+ ions from the blood.

Thus, carbonic acid can raise or lower the pH of blood.

Carbonic acid work to maintain blood pH as follows:

This means that, carbonic acid works to maintain blood pH as follows:

Learn more about buffers at: https://brainly.com/question/24188850

Answer:

nuclear wastes can be safely disposed of

Explanation:

In comparing fossil fuel power plants with nuclear power plants, it is obvious that fossil fuel power plants lead to a large volume of emission of oxides of carbon and sulphur.

Also, a larger volume of coal needs to be burnt to generate energy compared to a minute amount of uranium fuel that can sustain a nuclear power plant for a long period of time thereby reducing the environmental damage associated with mining of the fuel.

However, the problem of nuclear waste disposal have remained a thorn in the flesh. It is often difficult to safely dispose of spent uranium fuel. This is a major disadvantage of the use of nuclear power.

I'm gonna guess E on this one, but I think you should choose either E or A

Answer:

A. Yes

B. The new temperature of the gas is -116 °C

Note: The question is incomplete. The complete question is given below :

For many purposes we can treat butane C H10) as an ideal gas at temperatures above its boiling point of - 1. °C. Suppose the pressure on a 500 mL sample of butane gas at 41.0°C is cut in half. Iyes Is it possible to change the temperature of the butane at the same time such that the volume of the gas doesn't change? yes no If you answered yes, calculate the new temperature of the gas. Round your answer to the nearest °C.

Explanation:

A. According to the pressure law of gases,for a fixed mass of gas the pressure of a gas is directly proportional to its Kelvin temperature once the volume is kept constant. This means that a change in temperature can bring about a change in pressurein a gas at constant volume.

B. From the pressure law of gasese: P1/T1 = P2/T2

Where initial pressure = P1, final pressure = P2

Initial temperature = T1, final temperature = T2

For the butane gas;

P1 = P

P2 = P/2

T1 = 41°C = (273 + 41 ) K = 314 K

T2 = ?

From the equation, T2 = T1 × P2 / P1

T2 = 314 × P/2 /P

T2 = 157 K

T2 = (157 - 273) °C = -116 °C

Therefore, the new temperature of the gas is -116 °C

Answer:

D. 331 mm Hg

Explanation:

We can solve this problem by keeping in mind the law of partial pressures, which states that the total pressure of a mixture of gases is equal to the sum of the partial pressures of its components.

In other words:

We input the given data:

And calculate the pressure of the nitrogen:

[tex]\huge{\textbf{\textsf{{\color{pink}{An}}{\red{sw}}{\orange{er}} {\color{yellow}{:⌐■-■}}}}}[/tex]

Definition:-

The organ of government that primarily looks after the function of implementation and administration is called the executive.

Function:-

Executive is the branch of government responsible for the implementation of laws and policies adopted by the legislature.

Answer:

B, No reaction will occur

Explanation:

Copper as compared to lead is less reactive. This is the reason when  lead is added to copper nitrate solution, it replaces the copper and itself combines with nitrate to form lead nitrate aqueous solution

Lead + Copper(II) nitrate → Copper + Lead (II) nitrate

The same is not the case when the reaction is revered i.e Cu is added to Pb NO3 solution.

Hence, option B is correct

maybe umm think so pick think so

Answer:

1.96 × 10²⁴ molecules

Explanation:

Step 1: Given data

Mass of ethanol (m): 150. g

Step 2: Calculate the number of moles (n) corresponding to 150. g of ethanol

The molar mass of ethanol is 46.07 g/mol.

150. g × 1 mol/46.07 g = 3.26 mol

Step 3: Calculate the number of molecules in 3.26 moles of ethanol

To convert moles into molecules, we need Avogadro's number: there are 6.02 × 10²³ molecules in 1  mole of molecules.

3.26 mol × 6.02 × 10²³ molecules/1  mol = 1.96 × 10²⁴ molecules

The statement that is correct about Urban areas is that they have higher temperatures.

Urban Area is a term to refer to cities. Urban areas are characterized by having a developed infrastructure (wide roads, vehicular bridges, wide platforms, tall buildings, residential areas, industrial areas, among others).

Recent studies affirm that urban areas are warmer than surrounding areas; This phenomenon is because the materials with are built buildings, roads, houses, and others, concentrate the sun's rays, increasing the temperature of cities. In addition, the lack of trees deepens this phenomenon, because the trees contribute to cooling by physicochemical processes such as evapotranspiration.

According to the above, it is possible to affirm that urban areas are hotter than their surrounding area because they lack vegetation, and the materials with which it is built contribute to the increase in temperature.

On the other hand, urban areas are characterized by habitat fragmentation, more problems with soil erosion, and less rain infiltration into the soil.

Learn more in: https://brainly.com/question/23587978

Answer:

A) higher temps

Explanation:

Answer: [tex]K_{eq}[/tex] at  the temperature of the experiment is 0.56.

Explanation:

Moles of  [tex]CO[/tex] = 0.35 mole

Moles of  [tex]H_2O[/tex] = 0.40 mole

Volume of solution = 1.00 L

Initial concentration of [tex]CO[/tex] = [tex]\frac{0.35mol}{1.00L}=0.35M[/tex]

Initial concentration of [tex]H_2O[/tex] = [tex]\frac{0.40mol}{1.00L}=0.40M[/tex]

Equilibrium concentration of [tex]CO[/tex] = [tex]\frac{0.19mol}{1.00L}=0.19M[/tex]

The given balanced equilibrium reaction is,

                      [tex]CO(g)+H_2O(g)\rightleftharpoons CO_2(g)+H_2(g)[/tex]

Initial conc.          0.35 M         0.40 M                  0 M        0M

    At eqm. conc.     (0.35-x) M   (0.40-x) M   (x) M      (x) M

Given:  (0.35-x) = 0.19

x= 0.16 M

The expression for equilibrium constant for this reaction will be,

[tex]K_{eq}=\frac{[CO_2]\times [H_2]}{[CO]\times [H_2O]}[/tex]  

Now put all the given values in this expression, we get :

[tex]K_{eq}=\frac{0.16\times 0.16}{(0.35-0.16)\times (0.40-0.16)}[/tex]

[tex]K_{eq}=\frac{0.16\times 0.16}{(0.19)\times (0.24)}=0.56[/tex]

Thus [tex]K_{eq}[/tex] at  the temperature of the experiment is 0.56.

Answer:

Greenhouse gases absorb some of the energy and trap it in the lower atmosphere. Less heat radiates into space, and Earth is warmer. Many greenhouse gases occur naturally. Carbon dioxide, methane, water vapor, and nitrous oxide are naturally present in Earth's atmosphere. Since some of the extra energy from a warmer atmosphere radiates back down to the surface, Earth's surface temperature rises.

Hope this helped! :)