Answer:
They are both listed under group 11 on the periodic table and both are highly conductive of electricity
Explanation:
HOPE THIS HELPS ^^
A reaction yields 6.26 grams of a CuCl2. What is the percent yield of CuCl2 if the theoretical yield is 18.81g?
% Yield = (Actual Yield/Theoretical Yield) x 100
Answer:
33% yield
Explanation:
6.26/18.81 =0.33280170122 = 33%
14. A 70 N tight rope walker is walking 20 meters above ground. About how much Gravitational Potential Energy does the performer have? 1,400 J 1,200 J 800 J
Answer:
It is 1,400 j
Explanation:
That is what i know
Answer:
1,400J
Explanation:
the formula for calculating Gravitational Potential Energy is mass×gravitational field strength×height
70×10×20=1,400
helppppp will mark brainlest
Answer:
if you will decrease the HCO3- so the less H+ ion will be form and reaction will more likely shift to product and when HCO3- decreases pH value increases and vica versa for the increasing HCO3 the more H+ ion will be form and reaction will shift to product and the pH value will decreases!!
I've doubt in reaction shift coz whatever is the amount of HCO3- this is completely gonna form number of H+ so reaction shift may or may not be same!!
25) Which of the following would exert the most pressure on the ground? 3 points
A woman standing in running shoes
O A Woman standing in high heels
A woman sitting on the ground
O It doesn't make any difference as long as the weight is the same.
C
ادا آمد
collina abinet avontually
Answer:
a women standing in high heels
Explanation:
Answer:
A woman standing in high heels
Use the drop-down menu to complete the statement. This is why they have similar Atoms of elements in the same group have the same number of chemical properties.
Answer:
valence electrons
Explanation:
i just took the test
what is the difference between an enzyme and an inhibitor?
Madison is heating two different liquids. For each liquid, she wants to compare the temperatures at which gas bubbles form, rise, and begin to escape. What physical property is Madison using to compare the liquids?Immersive Reader boiling point conductivity melting point solubility
Answer:
I think its boiling point conductivity
Answer: boiling point
Explanation:
Got it right
H2SO4 + 2NaOH → Na2SO4 + 2H2O what volume of water vapor will be produced if you start with 71.5 g of sulfuric acid and excess of sodium hydroxide
Answer:
Explanation:
Find the molar mass of H2SO4
2H = 2 * 1 = 2
S = 1 * 32 =32
O4 = 4*16 = 64
total 98
Find the number of mols in 71.5 grams
mols = given mass / molar mass.
given mass = 71.5
molar mass = 98
mols = 71.5/98
mols = 0.7296 mols of H2SO4
Find the moles of H2O
From the Balanced equation, every mol of H2SO4 produces 2 moles of H2O
mols water = 2 * 0.7296
mols water = 1.4592
That's as far as I can take you. I have to know a great deal more to get the volume of H2O
What is the potential energy of a rollercoaster if it weighs 1565 kg and sits on a 115 m tall ride?
Answer:
Explanation:
Potential energy builds as the coaster is going up the loop-the-loop and converts to kinetic energy on the way down and out of the loop-the-loop. The potential energy of the coaster is at its lowest and the kinetic energy is at its highest as the coaster moves in the lowest point of the loop-the- loop.
1. Why is the timing of tides predictable?
A. because winds are predictable
B. because the moon’s path is predictable
C. because ocean water density is predictable
D. because the sun’s movements are predictable
Answer:
Because the moon's path is predictable
Explanation:
The moon affects the tides
Balance C12H22011 → C + H2
Answer:
What is this?
Explanation:
the formula equation of Acetylene + oxygen ----> carbon dioxide + water
Answer:
The final balanced equation is : 2C2H2+5O2→4CO2+2H2O.
What is the mass of sulfuric acid, h2so4, that is contained in 2.0L of a 5.85 M solution ?
A- 1147.44 grams
B- 0.12 grams
C- 11.7 grams
D- 98.07 grams
Answer:
A. 1147.44 grams
Explanation:
Multiply volume by molarity to get the moles of solution.
5.85 M = mol/2.0 L
mol = (5.85 M)(2.0 L)
mol = 11.7
There is 11.7 moles of H2SO4.
Convert to grams with molar mass.
11.7 mol H2SO4 x (98.076 g/1 mol) = 1147.49 g
Closest answer is A, 1147.44 g.
Complete the following statements of Dalton's atomic model: a) Elements are composed of minute, particles called atoms. b) Atoms of the same element are alike in and size. c) Atoms of different elements have different and sizes. d) Chemical are formed by the union of two or more different atoms of different elements. e) Atoms combine to form compounds in simple numerical , such as one to one, one to two, etc. f) Atoms of two may combine in different ratios to form more than one compound.
Answer:
a. Indivisible.
b. Mass.
c. Masses.
d. Compound.
e. Elements.
Explanation:
An atom can be defined as the smallest unit comprising of matter that forms all chemical elements. Thus, atoms are basically the building blocks of matters and as such defines the structure of a chemical element.
Generally, these atoms are typically made up of three distinct particles and these are protons, neutrons and electrons.
Hence, all the physical properties of a mineral result from the mineral's internal arrangement of atoms.
The following are statements postulated by the Dalton's atomic model;
a) Elements are composed of minute, indivisible particles called atoms.
b) Atoms of the same element are alike in mass and size.
c) Atoms of different elements have different masses and sizes.
d) Chemical compound are formed by the union of two or more different atoms of different elements.
e) Atoms combine to form compounds in simple numerical ratios, such as one to one, one to two, etc.
f) Atoms of two elements may combine in different ratios to form more than one compound.
Which of the following balances has the least uncertainty? (PSS.1)
Group of answer choices
platform balance, +/- 0.1 g
analytical balance, +/- 0.0001 g
All balances have the same uncertainty
triple-beam balance, +/- 0.01 g
electronic balance, +/- 0.001 g
Benadryl, C17H21NO, is an over-the-counter drug used to treat allergy symptoms. If each dose of Benadryl contains 5.89 x 10^19molecules of Benadryl, how many moles is this equal to?
Answer:
9.78x10^(-5) mol
Explanation:
To convert molecules to moles, divide the # of molecules by 6.02x10^23.
5.89x10^19 / 6.02x10^23 = 9.78x10^(-5) mol
What form of electromagnetic radiation does gamma radiation use?
Answer:
Gamma-rays are a form of electromagnetic radiation, as are radio waves, infrared radiation, ultraviolet radiation, X-rays and microwaves. Gamma-rays can be used to treat cancer, and gamma-ray bursts are studied by astronomers.
Explanation:
Hope this helped Mark BRAINLIEST!!!
Gamma Rays are ionizing Electromagnetic radiation, obtained by the decay of an atomic nucleus. Gamma rays are more penetrating, in matter, and can damage living cells to a great extent. Gamma rays are used in medicine (radiotherapy), industry ( Sterilization and disinfection) and the nuclear industry.
How many militias of 5.0 M H2SO4 (aq) stock silly toon are needed to prepare 100. Ml of 0.25 M H2SO4 (aq)
Answer:
5 mL
Explanation:
As this is a problem regarding dilutions, we can solve it using the following formula:
C₁V₁=C₂V₂Where subscript 1 refers to the initial concentration and volume, while 2 refers to the final C and V. Meaning that in this case:
C₁ = 5.0 MV₁ = ?C₂ = 0.25 MV₂ = 100 mLWe input the data:
5.0 M * V₁ = 0.25 M * 100 mLAnd solve for V₁:
V₁ = 5 mLAnswer:
5 mL of 5.0 M H₂SO₄ (aq) are needed to prepare 100 mL of 0.25 M H₂SO₄ (aq).
Explanation:
In chemistry, dilution is the reduction of the concentration of a chemical in a solution.
Then, dilution consists of preparing a less concentrated solution from a more concentrated one, and it consists simply by adding more solvent to the same amount of solute. That is, the amount or mass of the solute is not changed, but the volume of the solvent varies: as more solvent is added, the concentration of the solute decreases, since the volume (and weight) of the solution increases.
A dilution is calculated by the expression:
Ci*Vi = Cf*Vf
where:
Ci: initial concentration Vi: initial volume Cf: final concentration Vf: final volumeIn this case, you know:
Ci=5 MVi= ?Cf= 0.25 MVf= 100 mLReplacing:
5 M*Vi = 0.25 M* 100 mL
Solving:
[tex]Vi= \frac{0.25 M*100 mL}{5 M}[/tex]
Vi= 5 mL
5 mL of 5.0 M H₂SO₄ (aq) are needed to prepare 100 mL of 0.25 M H₂SO₄ (aq).
1. A sample of oxygen gas has a volume of 150 ml when its pressure is 440 mmHg. If the pressure is
Increased to standard pressure and the temperature remains constant, what will the new volume be?
Answer:86.84
Explanation:
was
4. When a 1.25-gram sample of limestone, that contains CaCO3 (molar mass = 100 g/mol) and inert impurities
dissolved in acid, 0.22 grams of CO2 was generated (molar mass = 44 g/mol). What was the percent of CaCO3 by
mass in the limestone?
CaCO3 + CO2 + CaO
(a) 20%
(6) 40%
(c) 67%
(d) 80%
(e) 100%
sort each characteristic according to whether it describes acid, bases, or both.
Answer:
Acids: react with metals, taste sour
Both: can cause burns, conduct electricity
Basis: react with nonmetals, taste bitter
Explanation:
This is the right answer
Answer:
Acids: react with metals, taste sour
Both: can cause burns, conduct electricity
Basis: react with nonmetals, taste bitter
it's right, I did it.
A certain type of material allows electricity to flow through it, but it does not flow quickly or easily through it. Is the material a good or poor conductor? Does it have a low or high resistance?
Predict Will you find starch in a plant leaf grown in the light? Why?
Answer:
You would find starch in a plant leaf.
Explanation:
This is due to the fact that when there is excess energy, it will be stored in plant tissue as starch.
What is a buffer used for?
A. To limit the pH change in a solution
B. To prevent an acid from dissociating
C. To neutralize the pH of a solution
D. To prevent a salt from dissolving
A buffer is primarily used to limit the pH change in a solution. Option A is correct.
A buffer is the solution which contains the weak acid and its conjugate base or weak base and its conjugate acid. It is designed to resist changes in pH when small amounts of acid or base are added to it.
When an acid or base is added to a buffer solution, the buffer components react with the added ions to minimize the impact on the solution's pH. If an acid is added, the buffer will react with the acid by accepting the H⁺ ions. If a base is added, the buffer will react with the base by donating H⁺ ions. In both cases, the buffer helps maintain the pH at a relatively stable level.
To prevent an acid from dissociating, is not accurate. A buffer does not prevent an acid from dissociating. In fact, the acid in a buffer solution is necessary to provide the conjugate base and maintain the buffer's pH buffering capacity.
To neutralize the pH of a solution, is also not accurate. A buffer does not neutralize the pH of a solution to a particular value. Instead, it resists significant changes in pH when small amounts of acid or base are added.
To prevent a salt from dissolving, is unrelated to the purpose of a buffer. A buffer is not used to prevent the dissolution of salts.
Hence, A. is the correct option.
To know more about buffer here
https://brainly.com/question/31847096
#SPJ2
This figure illustrates which of the following? gamma emission
fusion
chain reaction
beta emission
Answer:chain reaction
Explanation:
Sooner or later your new school won't feel so strange.get.
I'm hoping the same for my new coaching classes
This is my first time going out to study ngl-
Decomposition of potassium chlorate are performed in the lab to make oxygen. You are strictly advised to be careful with it. Why is that, what might happen?
Question 2
1 pts
Which of the following best describes what families/groups of elements have in common?
O Same number of electrons
O Same number of valence electrons
O Same number of electron shells
O Same number of protons
U
Question 3
1 pts
How many possible Mole Ratios are in the following reaction:
ZnO + 2 HCl --> ZnCl2 + H2O
Answer: 2 moles
Explanation:
How is thermal energy transferred between two objects that are at different temperatures?
Group of answer choices
Heat flows from the object that has more thermal energy to the object with less thermal energy.
The object at a lower temperature pulls heat from the warmer object.
Heat flows from the warmer object to the cooler object until they reach the same temperature.
Heat flows back and forth between the two objects untl they reach the same temperature.
Answer:
heat flows from the object that has more thermal more energy to the object with less thermal energy