no links pls it’s very unhelpful

Answer:

1.They are reliable.

2.They dont vary from person to person

Answer:

160 mL

Explanation:

Answer: A 13.88 mL of the concentrated acid would be required to make 250. mL of a 1.00 M [tex]H_{2}SO_{4}[/tex] solution.

Explanation:

Given: [tex]M_{1}[/tex] = 18.0 M,     [tex]V_{1}[/tex] = ?

[tex]M_{2}[/tex] = 1.00 M,         [tex]V_{2}[/tex] = 250 mL

Formula used to calculate the volume of concentrated acid is as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}[/tex]

Substitute the values into above formula as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}\\18.0 M \times V_{1} = 1.00 M \times 250 mL\\V_{1} = \frac{1.00 M \times 250 mL}{18.0 M}\\= 13.88 mL[/tex]

Thus, we can conclude that 13.88 mL of the concentrated acid would be required to make 250. mL of a 1.00 M [tex]H_{2}SO_{4}[/tex] solution.

Answer:

d. 3.0

Explanation:

First we calculate the pOH of the solution, using the following formula:

Using the pOH we can calculate the pH of the solution, keeping in mind the relationship between pH and pOH:

The answer is option d.

Answer:

the property of air shown in the figure describe A.mass

Answer:

Zn+2

Explanation:

I'm sorry if its wrong but have a good one!

Answer:

they end up bouncing against each other instead of merging together

Explanation:

Answer:

Carbon and oxygen are similar in a few ways. They are both elements, which are the fundamental building blocks of all matter. This means that they both have protons and electrons. They also both have neutrons

Answer:

2.33M

Explanation:

1. First, make sure the equation is balanced. In this case it would be HNO3+NaOH --> NaNO3 + H2O. (it is already balanced here.)

2. Find the initial volume, final volume, the volume of acid, volume of NaOH.

      a. Initial Volume: 4.85 mL

      b. Final Volume: 43.69

      c. Acid (HNO3) Volume: 5 mL

      d Volume NaOH: Initial V - Final V --> 43.69 mL - 4.85 mL = 38.84 mL NaOH

3. Find moles of NaOH reacted using the volume from D. Convert this volume into Liters. Multiply the volume of NaOH by molarity of NaOH given to you before. (.30 M NaOH)

      a. x mol NaOH/ .03884 L = .30 mol NaOH/ 1 mol = .011652 mol NaOH

4. Now find the moles of acid. The acid given to you in the equation is HNO3. The .011652 mol NaOH is from the moles reacted that you just found. The moles on the right side would be the co-efficient in front of the elements in the equation. Since this equation does not have any coefficients (it's already balanced), it would just be 1.

      a.  .011652 mol NaOH/ x mol HNO3 = 1 mol NaOH/ 1 mol HNO3.

                       x = .011652 mol HNO3

5. Now find the concentration, also known as molarity. Divide the .011652 mol by the volume of acid you have been given (5 mL). Before using 5 mL, divide it by 1000 to get the Liter form.

     a. .011652 mol HNO3/ .005 L = 2.3304 M HNO3

I hope you understand now. God bless!

Answer:

The solubility of a saturated solution can be increased by increasing the temperature.

Explanation:

Temperature -- Generally, an increase in the temperature of the solution increases the solubility of a solid solute. For example, a greater amount of sugar will dissolve in warm water than in cold water. A few solid solutes, however, are less soluble in warmer solutions.

Answer:

0.74

Explanation:

this is the correct answer. I followed a correct answer that had the same probelm with different values, swithxed it with mine, and got 0.75. So its basically 0.74

Answer:

8 meters per second per second

Explanation:

Newton's second law: [tex]f=ma[/tex], force = mass multiplied by acceleration.

Therefore 56 / 7 = acceleration = 8

Explanation:

Souring of milk

Baking of cake

Answer:

Lithium Cation is a monovalent cation that is metabolized much like sodium and is important in many cellular functions inside or on the surface of cells. lithium has a single valence electron that is easily given up to form a cation. Because of this, lithium is a good conductor of heat and electricity as well as a highly reactive element, though it is the least reactive of the alkali metals

Answer:

Heyaa!! Im Pinky and Im here to inform you that your answer is...

Explanation:

!!! 36.8189451 Grams !!!

  Have an amazing day!!!

~Pinky~!!

Radioactive elements are the elements into which an atom is very unstable or highly reactive because it is having more energy in its nucleus. stable elements are those who have stable and there shell are properly filled with electrons.

Most radioactive chemical elements have one or more radioactive isotopes on the other hand  some chemical elements only have one type of radioactive isotopes.

A radioactive element has an unstable nucleus that emits particles in the form of alpha, beta, or gamma radiation and stable element have stable nucleus with no effect of any radiation or energy due to fully filled orbitals.

Bombarding of these radiations has to be done in the nucleus of the element after this the desired element will become a radioactive element. And there is no effect of these rays on stable elements beacuse they are unreactive to this.

The ray of alpha beta and gamma consists of some charges within them and they are radioactive radiations harmful to human eyes.

Learn more about radioactive elements, here:

https://brainly.com/question/13234158

#SPJ2

Answer: The statement collisions only result in a reaction if the particles collide with a certain maximum energy called the activation energy of the reaction, is false.

Explanation:

Activation energy is the minimum amount of energy required to initiate a chemical reaction.

So, when activation energy for a reaction is lower then molecules with lower energy can also participate in the reaction. As a result, more number of collisions will take place due to which an increase in the rate of reaction will takes place.

When activation energy for a reaction is larger then molecules with higher energy will not be able to participate in the reaction. As a result, less number of collisions will take place due to which a decrease in rate of reaction will occur.

Therefore, we can conclude that the statement collisions only result in a reaction if the particles collide with a certain maximum energy called the activation energy of the reaction, is false.

Answer:

true

Explanation:

particularly must collide with energy equal to or greater the

Answer:

See explanation below

Explanation:

To get this, we need to apply the general expression for half life decay:

N = N₀e(-λt)    (1)

Where:

N and N₀ would be the final and innitial quantities, in this case, masses.

t: time required to decay

λ: factor related to half life

From the above expression we need λ and t. To get λ we use the following expression:

λ = t₁₂/ln2   (2)

And we have the value of half life, so, replacing we have:

λ = 8.04 / ln2 = 11.6

Now, we can replace in (1) and then, solve for t:

0.75 = 40 exp(-11.6t)

0.75 / 40 = exp(-11.6t)

ln(0.01875) = -11.6t

-3.9766 = -11.6t

t = -3.9766 / -11.6

Answer:

oxygen (O2) is a molecular element

Explanation:

Molecular compound are chemical compounds that take the form of discrete molecules.

atomic element is an element which occurs independently as atoms and can react with other elements to form a compound

Ionic compounds are the compound which on dissolution form ions in solution

Mixture is the composition of different compounds

Answer:

Both roots are imaginary roots.

Explanation:

Consider these things:

If we try to solve x²+1 = 0, notice that we aren't able to solve the equation in Real Number system because there are no negative outputs for quadratic function.

Remember that quadratic function has range greater or equal to the max-min value.

x-axis plane represents the solutions of that equation. If a graph intersects x-axis plane then it has a solution.

While a graph that doesn't have any intersects on x-plane, it means that the equation for that graph doesn't have real solutions but imaginary solutions.

As you may notice some of parabola graph has one intersect, two intersects or none. One intersect is one solution to the equation — Two intersects are two solutions of the equation and lastly, no intersects mean that no real solutions and remain only imaginary solution.

Answer:

Chemical reactions and physical transformations do not create or destroy mass in an isolated system, according to the law of conservation of mass. The mass of the products in a chemical reaction must equal the mass of the reactants, according to the conservation of mass law. The law of conservation of mass can be used to solve for unknown masses, such as how much gas is consumed or produced during a reaction.

Answer:

when you have a fever your body is trying to fight off a virus or some other kind of bad Bacteria  

Explanation:

I think this because everyone has at least had a fever when they were sick and when you are sick you are likely to have a fever because your body is fighting off a bad bacteria  

Answer:

27.3 days

Explanation:

I really have no explanation lol.

Answer:

Hope thia helps

Explanation:

it takes 27.3 days!!!

Answer:  Mass is 2,37 kg

Explanation: Weight G = mg, and g = 9.81 m/s² on Earth.

m = W/g = 23.2 N /  9.81 m/s²

Answer:

Neutrons and protons

Explanation:

There are three fundamental subatomic particles, these are;neutrons protons and electrons.

Ernest Rutherford successfully showed that every atom does possess a central core that contain positively charged particles (protons) called the nucleus. Chadwick later discovered the existence of neutrons.

Both protons and neutrons are found in the nucleus. Z represents the nucleus of the boron atom and houses the neutrons and protons of the boron atom.

Answer:

0.333J/g°C is the specific heat of the metal

Explanation:

The heat that the metaal gives is equal to the heat that water is absorbing. The equation is:

S(metal)*ΔT(metal)*Mass(metal) = S(H2O)*ΔT(H2O)*Mass(H2O)

Where S is specific heat, ΔT is change in temperature and mass the mass in grams of the metal and water.

Replacing:

S(metal)*(100.0°C-27.2°C)*125.0g = 4.184J/g°C*(27.2°C-24.3°C)*250.0g

S(metal) = 4.184J/g°C*(27.2°C-24.3°C)*250.0g / (100.0°C-27.2°C)*125.0g

S(metal) = 0.333J/g°C is the specific heat of the metal

Answer:

A) Mg + H2SO4 → MgSO4 + H2

B) CaCO3 + 2HCl → CaCl2 + H2O + CO2

C) CaO + H2O → Ca(OH)2

D) 3Ag + 4HNO3 → 3AgNO3 + H2O + NO2

Explanation:

A) Mg + H2SO4 → MgSO4 + H2

The equation is already balanced because the number of each element in the left hand side is already equal to that in the right hand side.

B) CaCO3 + 2HCl → CaCl2 + H2O + CO2

This equation is balanced by putting 2 in front of HCl on the left hand side to balance the elements on the right hand side.

C) CaO + H2O → Ca(OH)2

Thus equation is already balanced because the number of each element in the left hand side is already equal to that in the right hand side.

D) 3Ag + 4HNO3 → 3AgNO3 + H2O + NO2

This equation is balanced by putting 3 in front of Ag and 4 in front of HNO3 on the left hand side while we put 3 in front of AgNO3 on the right side to balance the elements on the right hand side.

Answer:

No

Explanation:

If tin is heated, it can react with alkalis' with the release of hydrogen.

Tin is a great metal that is used for packaging purposes.

However, if the tin in the tin can is replaced with alkali metals then they will readily react with the acid present in the food materials stored inside, thereby rendering the food unsafe.

https://brainly.com/question/18153051